Power-ON Utilities
There are three power-ON utilities to set up and test printer hardware. These
utilities are activated by pressing the FEED button (
power (
) simultaneously and release the button at different LED light
indications.
Power-ON Utility for standard panel
Follow the steps below for different power-on utilities.
1.
Turn off the printer power switch.
2.
Press down the FEED button (
3.
Release the power switch (
continue pressing the FEED button.
4.
The printer will beep twice, then release the FEED (
battery LED indicates the desired function:
Power ON Utilities
Standard Panel
LED
Release FEED
button
for
different functions
Media sensor calibration
Follow the steps below to calibrate the media sensor.
1.
Turn off the printer power switch.
2.
Hold on the FEED button (
3.
Release the power switch (
continue pressing the FEED button.
4.
The printer will beep twice, then release the FEED (
battery LED indicates
to left, 5 blinks each.
5.
The printer will calibrate the sensor and print out the internal settings,
then enter the DUMP mode. Turn the printer OFF/ON to exit DUMP
mode.
) then turn on the power switch (
) when LED color turns to amber,
Battery LED Configurations
(5 blinks)
Media sensor
calibration
calibration, self- test
and enter DUMP
) then turn on the power switch (
) when
LED color turn on amber,
and blinking. The LED will sequence right
~ 29 ~
) then turning on the printer
(No LCD Display)
) button when the
(5 blinks)
Media sensor
Printer initialization
Mode
) button when the
).
(5 blinks)
).