Hot Laminating Procedure; Cold Laminating Procedure - Royal Sovereign NPH-1200N Owner's Manual

HOT LAMINATING PROCEDURE

1. Place and use the laminator on a sturdy, flat work surface.
2. Plug in the laminator after verifying the correct outlet voltage.
3. Press the power button.
4. Make sure the machine is in the hot lamination mode by pressing the
HOT/COLD button.
5. Select the correct pouch thickness by pressing the program buttons up or down.
6. Set the temperature and speed according to the pouch thickness.
Please refer to the SPECIFICATIONS section for recommended settings.
7. The symbol will stop blinking and a
desired temperature is met. The machine is now ready for lamination.
8. Place the item to be laminated into the laminating pouch.
9. Insert the pouch (sealed side first) into the front opening of the machine.
10. The laminated item will exit out the rear of the machine when completed.
11. If you laminate several items continuously the
until it is displayed again before continuing lamination.
NOTE: Your laminated item will be hot and can easily bend. To keep your
laminated item flat, place on a flat surface and allow it to cool.

COLD LAMINATING PROCEDURE

1. Make sure the machine is in the cold lamination mode by pressing the
HOT/COLD button. You will see the
is in the cold temperature mode.
2. The symbol will stop blinking and a
temperature is met. The machine is now ready for lamination.
3. Place the document to be laminated on the adhesive side of the cold film with the
document face down.
4. Insert the document to be laminated into the front opening of the machine.
5. Remove paper liner from the cold film slowly while the document is being inserted
into the machine.
NOTE: When switching the machine from the hot to cold mode, please
wait until the rollers cool down. It will take approximately 6 minutes.
The symbol will appear and you will hear 3 beeps.
NPH-1200N/900N
symbol will appear when your
may disappear, please wait
displayed when the machine
symbol will appear when the cold
8