Table of Contents
Advertisement
1. HOT LAMINATING
1. Press the power button.
2. Choose setting by
3. When red LED stops blinking and buzzer rings, you're ready to laminate.
(It takes 4~5 minutes depending on setting function.)
4. Put document to be laminated, into a laminating pouch. Leave a minimum
border of about 3mm(1/8"), to provide a proper edge seal.
5. Insert pouch squarely into opening slot.
6. Finished lamination will exit through rear of machine.
7. Emerging laminated document is hot to the touch.
(Always allow lamination to cool down on a flat surface for about a minute before
handling, to prevent permanent bending. If document is not laminated well,
re-insert it and run it through a second time.)
8. When continuously laminating, run the laminator at a lower setting
because the internal machine temperature may be higher than
the required temperatur, causing the document to bend or ripple.
9. When finished laminating, turn off the machine.
* Sometimes, when continuously laminating, LED may begin blinking.
If this happens, finish laminating the current document, then wait
until the LED stops blinking, before inserting the next lamination.
* Do not laminate empty or thin pouch on a thick film setting.
The pouch could stick to the roller.
* Do not unplug laminator while laminating.
This could be fatal for the rollers due to the high internal temperature.
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
LAMINATING STEPS
or
***USEFUL INFORMATION***
9
Advertisement
Table of Contents
