Inet/Hp-Il Addresses - HP 5890 Series II Plus Reference Manual

Signal Output
INET configuration
Note that global mode has two states: if GLOBAL flashes (default mode)
when displayed, the HP 5890 is in global mode, but not configured into
the INET system. When the HP 5890 is properly configured into the
INET system, GLOBAL is displayed continuously. This feature provides a
convenient diagnostic to determine if system configuration has occurred
(at least as far as the HP 5890 is concerned).

INET/HP-IL addresses

Figure 5•10shows displays occurring either in verifying an INET address
set through automatic loop configuration or in entering a specific HP•IL
default address used when the HP 5890 is included in an HP•ILloop
without automatic configuration. The address is maintained in
battery•protectedmemory along with other instrument setpoints.
Figure 5-10
INET/HP-IL ADDR: Displays
Verifying the HP 5890 INET address
In Figure 5•10,note the two numeric values following ADDR:. The first
of these numbers is the INET address for the HP 5890, determined via
automatic loop configuration.
GLOBAL
DEFAULT ADDRESS
GLOBAL
ADDRESS LIMIT
ACTUAL SETPOINT
ADDR: 8,31
ACTUAL SETPOINT
* 25
ACTUAL SETPOINT
ADDR: 8,25
ACTUAL SETPOINT
= 31
87