HP 5890 Series II Plus Reference Manual page 19

Columns and Fittings
Liners/adapters and inserts, general
Table 1-3. Hardware and Recommended Fittings for Capillary Column Installation
Recommended
Column Fittings
Packed Column
Inlet Liners
Split/Splitless &
Split-Only
Capillary Inlet
Split Sampling
Split/Splitless
Capillary Inlet
Insert: Splitless
Sampling
Programmable
On-Column
Capillary Inlet
Insert
2
FID/NPD
Liners/Adapters
TCD
Liners/Adapters
ECD
Liners/Adapters
1
Use 1/4-inch swage-type nut (if a nut is not supplied as part of the adapter) and graphite or Vespel ferrule to
install liner/adapter.
2
0.11-inch jet must be used; see Chapter 8 for information regarding jet exchange (if necessary).
3
Use only if detector is not configured with capillary makeup gas adapter. If makeup adapter is provided, it is
used instead (usually with makeup gas turned off).
¿
HP Series 530
Capillary column
nut and 1.0-mm
graphite ferrule, or
silicone O-ring(s)
1
19244-80540
(requires glass
insert)
18740-60840
with graphite or
silicone O-ring
18740-80220
with graphite or
silicone O-ring
3
19245-20580
1
19244-80550
18740-20950
and
3
18740-20960
1 3
19244-80550 ,
Capillary Columns
¿
320 m ID 200
Capillary column Same as 320
nut and 0.5-mm
graphite or
silicone O-ring(s)
Not Not
Recommended Recommended
Same Same
Same Same
19245-20520 19245-20510
Same Same
1
19232-80550 Same
19233-80530 Same
¿
m ID Metal/
Glass
¿
m Same as
HP Series
¿
530
Not
Recom-
mended
Same
Same
19245-
20550
Same
Same
Same
19