Battery Condition; Bypass Is Out Of Range - HP R5500 User Manual

Off Off
Off Flashing
red
Off Off
Off Red
Off Flashing
red
Flashing Flashing
red red
Red Off
Flashing Off
red
Off Off
Flashing Off
red
For the location of individual LEDs, see "UPS front panel LED indicators (on page 8)."

Battery condition

Action:
Install the battery module. If the battery module is already installed, remove and reinsert the module.
1.
Allow the UPS batteries to charge for 48 hours.
2.
If the LED does not turn off, replace the batteries
3.
If the condition persists, contact an HP authorized service representative.
4.

Bypass is out of range

The input voltage is not within ±12 percent of nominal voltage.
The UPS is receiving utility power that might be unstable or in brownout conditions. The UPS continues to
supply power to the connected equipment. If conditions worsen, the UPS might switch to battery power.
Action:
Check the input voltage and reconfigure the UPS
1.
Contact a qualified electrician to verify that the utility power is suitable for the UPS.
2.
Flashing Off Off
red
Off Off Off
Flashing Off Off
red
Off Off Off
Off Off Flashing
red
Flashing Flashing Flashing
red red red
Off Off Off
Off Off Flashing
green
Off Red Off
Off Off Off
Off On—1 beep
every 5
seconds
Off On—1 beep
every 5
seconds
Off On—1 beep
every 5
seconds
Off On—1 beep
every 5
seconds
Off On—1 beep
every 5
seconds
Flashing On—
red Continuous
Off On—
Continuous
Off On—
Continuous
Off On—1 beep
every 5
seconds
Red On—
Continuous
("UPS battery replacement
("Configuring the UPS" on page 27).
Yes Battery test failure
("Battery condition" on
page 39)
No Low battery—No utility
power ("UPS is on
battery" on page 42)
Yes Batteries are
disconnected
condition" on page 39)
Yes On battery—No utility
power ("UPS is on
battery" on page 42)
Yes On battery—Input
voltage is out of range
(on page 40)
No Internal UPS fault
condition (on page 40)
Yes Battery condition (on
page 39)
Yes REPO condition (on
page 41)
Yes Site wiring condition
(on page 41)
Yes UPS power capacity is
exceeded ("Overload
condition" on page 41)
procedure" on page 35).
Troubleshooting 39
("Battery