Removing the ERM front bezel
Replacing the UPS electronics module
This component is hot-swappable and can be replaced without powering down the UPS.
(optional) To replace the component with the UPS powered down, refer to "Powering down the UPS
1.
(on page 29)."
Disconnect the communications cable from the option card.
2.
Remove the option card
3.
Remove the UPS front bezel
4.
Remove the screw securing the electronics module and slide the module out.
5.
Replace the electronics module. Be sure the electronics module is firmly seated in the connector.
6.
("Replacing the UPS option
("Removing the UPS front
card" on page 33).
bezel" on page 31).
Maintenance 32