Alarm Detect - Bosch VEZ-5000 Operation Manual

AUTODOME 5000 Analog PTZ Camera
Autopan
Select an Auto Pan line that the camera should execute when the alarm pin is triggered. The
Auto Pan line(s) should be defined prior either in the AUTOPAN setup menu or through the
keyboard.
Tour
Select a tour line that the camera should execute when the alarm pin is triggered. The tour
line(s) should be defined prior either in the TOUR setup menu or through the keyboard.
Dwell Time
The dwell time is the duration for executing the alarm action. If the PRESET mode is selected,
the camera will go to the selected Preset position and stay there for a user-defined period of
time (1 ~ 127 seconds / Always) when the alarm pin is triggered, until the alarm condition is
released or you rotate the joystick to change the status of the camera.
If any other modes (PRESET TOUR / AUTOPAN / TOUR) is selected, the camera will keep
executing the selected mode (DWELL TIME: ALWAYS) until the alarm condition is released or
you rotate the joystick to change the status of the camera.
Notice!
The dwell time is only adjustable when PRESET is selected as the alarm action. When the
dwell time is up, the camera will go back to its triggered position and recheck alarm pin
status.
Alarm Priority
Set alarm priority from <1> to <4> for each alarm pin. If two or more alarms are triggered at
the same time, smaller alarm priority number will have higher priority to be handled. The
default alarm priority is <1>.
Alarm Output
There are two available alarm outputs for the camera. You can set <1>, <2>, <1+2> or <OFF> to
activate the alarm output devices when the pin alarm is triggered.
6.14.2

Alarm Detect

When the Alarm Detect function is activated, the camera will detect movement within a
predefined monitoring area and will send alarm signals automatically when any motion is
detected. There will be a flash warning notice "MOTION" displayed at the upper left corner of
the screen.
Motion Detection
Block Mode
Frame Set
Frame Disable
Threshold
Exit
Motion Detection
This item is used to enable (ON) or disable (OFF) the Motion Detection function. The Motion
Detection function allows the camera to monitor for suspicious motion and trigger an alarm
when motion volume in the detection area exceeds the specified sensitivity threshold value.
Bosch Security Systems, Inc.
ALARM DETECT
Off
Off
01
01
014
Yes
Operations Manual
On-Screen Display (OSD) Menu | en 55
2013.07 | 1.3 |