Bosch VEZ-5000 Operation Manual page 56

56 en | On-Screen Display (OSD) Menu
Block Mode
Select <ON> to enable highlighting of detected motion in the monitoring area. Select <OFF> to
disable highlighting of detected motion.
Frame Set
You can define specific areas as motion detection target zones. Refer to the instructions as
follows to configure parameters for each motion detection zone so-called "Frame." A total of
four frames can be set. Select the number of frame using the LEFT/RIGHT keys, and press the
<CAMERA MENU> key to enter the FRAME SET submenu.
Left Limit
Top Limit
H Size
V Size
Mode
Preset
Dwell Time
Exit
–
–
–
–
–
–
2013.07 | 1.3 |
FRAME SET
L/R
U/D
+/-
+/-
Preset
001
003 Sec
Yes
Left Limit
Move the frame to the left/right using the LEFT/RIGHT keys.
Top Limit
Shift the frame up/down using the LEFT/RIGHT keys.
H / V Size
Adjust the frame size via changing the Horizontal / Vertical size value using the LEFT/
RIGHT keys.
Mode
Assign a trigger action for the motion detection frame. Options include PRESET, PRESET
TOUR, AUTOPAN and TOUR. When motion is detected in the frame, the camera will
execute the selected trigger action.
Mode Line
After you select a trigger action for MODE, you can specify the MODE LINE of the selected
trigger action. According to different trigger actions, options for MODE LINE will be
different.
Dwell Time
The Dwell Time is the duration for executing the selected trigger action. If the PRESET
mode is selected, the camera will go to the selected Preset position and stay there for a
user-defined period of time (1 to 127 seconds / Always) when any motion is detected,
until the alarm condition is released or you rotate the joystick to change the status of the
camera.
If any other mode (PRESET TOUR / AUTOPAN / TOUR) is selected, the camera will keep
executing the selected mode (DWELL TIME: ALWAYS) until the alarm condition is
released or you rotate the joystick to change the status of the camera.
Operations Manual
AUTODOME 5000 Analog PTZ Camera
Bosch Security Systems, Inc.