Kodak i4000 Plus Series Setup Manual page 49

48
Sensors — three sensors cover the width of the paper path. In order for
multifed documents to be detected correctly, they must pass under one
of these sensors.
• Left, Center, Right: this allows you to select which sensor(s) you
want to have turned on or off. For example, if you know that the left
side of the document has a "sticky" note on it, you can turn off the left
sensor.
Length Detection — allows you to select the maximum length of the
documents in your job set. If the scanner detects a document longer
than this value, it will determine that a multifeed has occurred. You can
turn this option off.
Action When Detected — select what action you want the scanner to
take when a multifeed is detected. With all options, the condition will be
logged in the scanner.
• Stop Scanning: scanning will stop and control will return to the
scanning application (i.e., ends the job). Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
• Stop Scanning - generate image(s): scanning will stop and control
will return to the scanning application (i.e., ends the job). Image(s) of
the multifed document will be generated. Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
• Stop Scanning - leave paper in path: scanning will stop
immediately (i.e., making no attempt to clear the paper path) and
control will return to the scanning application (i.e., ends the job).
Clear any documents from the paper path prior to restarting the scan
session from the scanning application.
• Continue Scanning: the scanner will continue to scan.
• Pause Scanning: scanning will stop but the scanning application will
be waiting for additional images (i.e., stops the feeder). Scanning
may be resumed by pressing the Start/Resume button on the
scanner. Scanning may be stopped by pressing the Stop/Pause
button on the scanner or via the scanning application.
Play sound on PC — turn this option on if you want the PC to make a
sound when a multifeed is detected. You can click the Browse button to
select the desired .wav file.
NOTE: The sound on the PC may not occur at the exact time the
multifeed is detected by the scanner.
A-61653/TWAIN August 2013