Kodak i4000 Plus Series Setup Manual page 26

A-61653/TWAIN August 2013
- : Content amount will be filled in with the amount of content in
the preview image. If you have a representative blank document
(e.g., blank sheet with letterhead), this can be used to assist with
determining the setting for Content amount (i.e., perform a
preview scan, click this button, and adjust Content amount as
appropriate).
NOTE: This option is only available when there is a preview
image.
• Based on Size: images will be considered blank based on the size of
the image that would be given to the scanning application (i.e., after
all other settings have been applied).
- Final image size: allows you to select the minimum image size
that the scanner will consider to be non-blank. Any image that is
less than this value will be considered blank and will not be given
to the scanning application. The values range from 1 to 1000 KB
(1 KB equals 1024 bytes).
Image Edge Fill — fills the edges of the final electronic image by
covering the area with the specified color. This option is not applied to
the preview image.
• Color: allows you to select the color to fill the edges with.
- (none)
- White
- Black
• All sides match: when turned on, an equal amount will be filled in on
all sides.
• Top: determines how much of the top edge will be filled in.
NOTE: This option is applied to all edges when All sides match is
turned on.
• Left/Right: the option on the left will determine how much of the left
edge will be filled in and the option on the right will determine how
much of the right edge will be filled in.
• Bottom: determines how much of the bottom edge will be filled in.
NOTE: When using Image Edge Fill, be careful not to enter a value
too large as it could fill in image data that you want to keep.
25