Table of Contents
Advertisement
R
E. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in Figure 9.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod. Figure 9.1
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Door Cross
Latch Cam
Section
Locknut
Spacing
Washers
Figure 9.1
April 29, 2013
Door Handle Shaft
Square Key
Fiber Handle
7075-205
F. Baffle & Ceramic Blanket Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been partially
disassembled and the right side lowered. It is not necessary
to completely remove the tube channel assembly.
3. Once the baffle protection cover has been removed, pull
the baffle boards and ceramic blanket forward about 1 inch
(25mm) and then overlap the baffles about 1-2 inches (25-
51mm). Figure 9.2
4. Slide the tube channel assembly to the left as far as it will
go and lower the right side. Remove the baffle boards and
ceramic blanket together. Figure 9.3
4. Re-install in reverse order. Be sure the baffle boards and
ceramic blanket are in their proper positions.
Ceramic Blanket
Figure 9.2
Slide Tube Channel to the
Left and Lower Right Side
Figure 9.3
Voyageur Grand
Baffle Boards Overlapping
Page 13
Advertisement
Table of Contents
