Baffle & Ceramic Blanket Removal; Door Handle Assembly - Quadra-Fire VOYAGEUR-MBK Owner's Manual

VOYAGEUR
E. Baffle & Ceramic Blanket Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been partially
disassembled. Follow steps 1 through 4 on page 25 for
removal of the tube channel assembly. It is not necessary
to completely remove the tube channel assembly.
3. Once the baffle protection cover has been removed, pull
the baffle boards and ceramic blanket forward about 1
inch (25mm) and then overlap the baffles about 1-2 inches
(25-51mm). Figure 24.2.
4. Slide the tube channel assembly to the left as far as it will
go and lower the right side. Remove the baffle boards
and ceramic blanket together. Figure 24.1.
5. Re-install in reverse order. Be sure the baffle boards and
ceramic blanket are in their proper positions. See Figure
12 .1 on page 13.
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Figure 24.1
Ceramic Blanket
Figure 24.2
24
Baffle Boards Overlapping
F. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in Figure 24.3.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod. Figure 24.3.
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Latch Cam
Locknut
Spacing
Washers
Figure 24.3 - Door Handle for Arched Door
7063-512E
Door Cross
Section
Door Handle Shaft
Square Key
Fiber Handle
July 8, 2015