Table of Contents
Advertisement
Voyageur Grand
G. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1. Remove the 3 right side bricks.
2. Remove the baffle protection channel by bending back
the tabs using needle nose pliers located at the right and
left side of the protection cover. Lift the cover up slightly
and pull toward the front and out of the firebox. Figure
10.1
3. Locate the 2 channel nuts and two bolts inside of cham-
ber and remove using a 7/16 socket wrench. Figure
10.2
NOTE: Soak the bolts with penetrating oil for at least 15
minutes before trying to remove them.
4. Slide the tube channel assembly all the way to left until
it is off the threads. Drop the right side down, then slide
the assembly back to right. Figure 10.3
5. The ceramic blanket and both baffle boards can be
removed at the same time you remove the tube channel
assembly.
6. When the tube channel assembly is free of the left side
support, rotate clockwise and pull assembly, blanket and
baffles out through the front opening.
7. Re-install in reverse order.
Tube
2 Tube Channel Nuts
Channel
Assembly
Figure 10.3
Page 14
Ceramic Blanket
Baffle
Protection Channel
7075-205
Bend Back Tabs
Figure 10.1
Use 7/16 Socket Wrench
and Remove Channel Nuts
Figure 10.2
2 Baffle Boards
R
Baffle Protection
Channel
April 29, 2013
Advertisement
Table of Contents
