Snap Disc Replacement; Wiring Diagram; Door Handle Assembly - Quadra-Fire VOYA-GRAND-MBK Owner's Manual

VOYAGEUR GRAND
C. Snap Disc Replacement
1. The grille on the blower access assembly is hinged.
Swing the grille downward to expose the 2 screws. Fig-
ure 21.1 on page 21.
2. Remove the 2 screws from the blower access assembly
and slide assembly away from the appliance
3. Locate the snap disc bracket assembly behind the blower
controls on the right side under the ash lip. Figure 22.1
4. Remove the 2 mounting screws in the blower control
bracket and slide assembly towards you.
5. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and lift the snap disc off of the mounting
bracket. Disconnect the wires and replace with new snap
disc and re-connect the wires.
6. Slide the blower control bracket back into position and
secure with the 2 mounting screws.
Blower Controls & Snap
Disc Under Ash Lip
Figure 22.1 Snap Disc Location
22
D. Wiring Diagram
Snap Disc
Switch
E. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in Figure 22.2.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
Snap Disc
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod. Figure 22.2.
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Locknut
Figure 22.2 - Door Handle for Arched Door
7075-208D
Blower
Black White
Black
White
Rheostat
Door Cross
Latch Cam
Section
Square Key
Spacing
Washers
White
Power Cord
Black
Door Handle Shaft
Fiber Handle
July 8, 2015