Door Handle Assembly; Baffle Removal - Quadra-Fire 21M-ACC Owner's Manual

D. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 23.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to required 2 inch (51mm) clearance location
on door handle rod (Figure 23.1).
Door Cross Section
(example)
Latch Cam
Locknut
Spacing
Washers
Figure 23.1
E. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffle piece (Figure 23.2).
3. Remove the ceramic blanket.
4. Re-install the baffle pieces one piece at a time. Be sure
the baffle boards are even with the front manifold tube
and is resting on all tubes (Figure 23.4).
5. To re-install the ceramic blanket, it is easier to fold it
in half first. Place on top of baffle board, open up and
flatten and smooth out the blanket. Re-check the baffle
board for correct positioning (Figure 23.3).
Figure 23.2 - Baffle
August 13, 2018
2 inch (51mm) clearance
required from bend in door
handle rod to end of spring
handle.
Spring
Handle
Door Handle
Square Key
Figure 23.3 - Ceramic Blanket
Baffle Board even with front
tube & resting on all tubes
Ceramic Blanket on Top
Tube Channels
Figure 23.4
7039-177C
2100 Millennium
Burn Rate
Air Control
Automatic
Combustion
Control
2 pc Baffle Board
23