Alarm Upper Limit Value 1 (Al 1H), Alarm Lower Limit Value 1 (Al 1L) - Omron E5ZN Operation Manual

Operation Level
Settings
See Also
7-3-8 Alarm Upper Limit Value 1 (al
Alarm Lower Limit Value 1 (al
Function
Communications
Settings
See Also
118
FFFFF831H to 00000270FH (-1999 to 9999)
The alarm type must be set to other than no alarm or upper and lower limit
alarm (alarms 1 and 2 only).
• Related Parameters
"Input type" (initial setting level) (page 128)
"Scaling upper limit" "Scaling lower limit" "Decimal point" (initial setting
level) (page 129)
"Alarm 1 type" "Alarm 2 type" "Alarm 3 type" (initial setting level)
(page 132)
"Alarm 1 open for alarm" "Alarm 2 open for alarm" "Alarm 3 open for
alarm" (advanced function setting level) (page 138) "Alarm 1 hysteresis"
"Alarm 2 hysteresis" "Alarm 3 hysteresis" (advanced function setting
level) (page 139)
"Standby sequence reset method" (advanced function setting level)
(page 137)
al al al 1h
al 1l
al al
Condition: Alarm 1 type must be set to upper and lower limits, upper and
lower limit range, or upper and lower limit with standby sequence.
These parameters independently set the upper and lower limit alarm values
when the mode for setting the upper and lower limits is selected for alarm 1
type.
• These parameters set the upper and lower limit values of alarm 1.
• During temperature input, the decimal point position is dependent on the
currently selected sensor, and during analog input it is dependent on the
"decimal point" parameter setting.
Setting
Alarm upper limit value 1
Alarm lower limit alarm
value 1
FFFFF831H to 00000270FH (-1999 to 9999)
• Related Parameters
"Alarm 1 type" (initial setting level) ( page 132)
"Standby sequence reset method" (advanced function setting level)
( page 137)
"Alarm 1 open for alarm" (advanced function setting level) ( page 138)
"Alarm 1 hysteresis" (advanced function setting level) ( page 139)
Setting range
1h) 1h 1h
1l)
1l 1l
ch
1
2
1
2
Setting range
Section 7-3
Unit
EU
Variable type Address
C1 0005
C1 0105
C1 0006
C1 0106
Unit
EU
Default
0
Default
0