HP 8517B Operating & Service Manual page 50

5. View the S measurement. If the thru is connected, the transmission
21
coefficient should be 1 0 .
6. Press PARAMETER
{SELECT DEFAULTS}
{DEFAULT to MEMORY: 2}
7. Press PARAMETER
connected, the transmission coefficient should be 1 0 .
Normalization is turned OFF for S
appropriate memory is selected and normalization is turned on to view S
and S .
12
Since these are accurate, repeatable attenuators, this sequence may be
effective in your application. If other parts of the test must be changed,
especially components connected to the test ports, this procedure may
require additional steps to adequately compensate for the changes.
, then press the following
[S ]
12
to view the S measurement. If the thru is
[S ]
12 12
and S measurements. Then the
11 22
HP 8517B S-Parameter Test Set Manual 3-12
menu keys:
DISPLAY:
21