Using The Hp Setup Program - HP Kayak XU800 Technical Reference Manual

5 HP BIOS
HP/NBA BIOS Summary
An example of a released version would look similar to the following
example: IA.11.02.
The procedure for updating the System ROM firmware is described on
page 95.

Using the HP Setup Program

To run the Setup program, press
displayed immediately after restarting the PC.
Alternatively, press
summary screen will remain visible until a key is pressed.
The band along the top of the Setup screen offers the following menus:
Main, Advanced, Security, Boot, Power and Exit. These are selected using
the left and right arrow keys.
Main Menu
The Main Menu presents a list of fields, for example, "PnP Operating
System" (selects whether the BIOS or Plug and Play operating system
configures Plug and Play devices); "Reset Configuration Data", "System
Time", "System Date", "Key Click", "Key auto-repeat speed" "Delay before
auto-repeat" and Numlock at Power-on". By default the "Reset
Configuration Data" item is set to "No". Selecting "Yes", will clear the system
configuration data.
Advanced Menu
The Advanced Menu does not have the same structure as the Main Menu
and Power Menu. Instead of presenting a list of fields, it offers a list of
sub-menus. The Advanced Menu contains the following sub-menus:
Processors, Memory and Cache. Configures processor, CPU speed,
•
Processor Serial Number, memory controller and cache operations (error
correction, shadowing and caching).
Floppy Disk Drives. Enables or disables the on-board floppy disk
•
controller.
IDE Devices. Configures IDE devices. Setting of IDE Primary and Master
•
slave devices, and IDE Secondary Master slave devices. To use both these
channels, the Integrated BUS IDE adapter is set to
92
while the initial "Kayak" logo is
to view the summary configuration screen. The
.
Both Enabled