LanParty P45 T2RS User Manual page 127

CrossFire Setup
Note:
The system board used in the following illustrations may not
resemble the actual board. These illustrations are for reference
only.
1. Power-off the system and monitor then unplug the power cord.
2. Remove the screw of the bracket that is opposite the PCIE 1
slot then remove the bracket.
PCIE 1
3. Align the CrossFire Edition graphics card (Master) above the
PCIE 1 slot then press it down firmly until it is completely seated
in the slot.
4. Secure the graphics card with the screw you removed in step 2.
ATI CrossFire Technology
CrossFire Edition
graphics card
6
127