LanParty P45 T2RS User Manual page 38

2
Hardware Installation
IrDA and Serial (COM) Connectors
2
1
IrDA Connector
This connector is used to connect an IrDA module.
You may need to install the proper drivers in your operating system
to use the IrDA function. Refer to your operating system's manual or
documentation for more information.
Serial (COM) Connector
The serial (COM) connector is used to connect modems, serial print-
ers, remote display terminals, or other serial devices. Your COM port
may come mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then
connect the serial port cable to this connector. The colored edge of
the cable should align with pin 1 of this connector.
38
COM
9
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable connector to the IrDA
connector according to their pin functions.
IRRX
N. C.
VCC
1
1
IrDA
Ground
IRTX
5