Using Telnet - HP Integrated Lights-Out User Manual

Using Telnet

To use telnet, the iLO Remote Console Port Configuration and Remote Console
Data Encryption on the Global Settings screen must be configured as follows:
1. Set the Remote Console Port Configuration to Enabled.
2. Set the Remote Console Data Encryption to No.
You can open either a telnet based Remote Console session or a browser-based
Remote Console session. You cannot open both at the same time. An error
message is generated if both sessions are opened simultaneously.
To access iLO using telnet:
1. Open a telnet window.
2. When prompted, enter the IP address or DNS name, login name, and
To terminate a telnet session:
1. Press the Ctrl+] keys and press the Enter key at the prompt.
2. If you see an extra carriage return each time the Enter key is pressed, press
Telnet Simple Command Set
The following key sequences for simple command set are available for use
during telnet sessions. These commands are available only when in a telnet-based
Remote Console or Virtual Serial Port session.
Action
POWER ON
password.
NOTE: Access through telnet will be disabled, if the remote console
port configuration on the Global Settings tab is set to Disabled or
Automatic, or if remote console data encryption is enabled.
the Ctrl+] keys and enter set crlf off at the prompt.
Refer to "iLO VT100+ Key Map (on page 119)" for a complete list of key
sequences.
Key Sequence
CTRL P 1
Comments
CTRL P is the prefix for the Power
commands. The 1 indicates an ON
selection.
Using iLO 117