HP Integrated Lights-Out User Manual page 70

70 User Guide Integrated Lights-Out
2. Select Virtual Media in the Virtual Devices tab.
3. Insert the media into the local floppy drive, select a diskette drive, and click
In NetWare 6.5, use the lfvmount command on the server console to assign
the device a drive letter.
The NetWare 6.5 operating system will pick the first available drive letter for the
Virtual Floppy drive. The volumes command can now be used by the server
console to show the mount status of this new drive.
When the drive letter shows as mounted, the drive will now be accessible
through the server's GUI as well as the system console.
When the Virtual Floppy Drive is mounted, if the media is changed in the local
floppy drive, the lfvmount command must be re-issued on the server console
to see the new media in the NetWare 6.5 operating system.
Mounting USB Virtual Media Floppy in Linux
1. Access iLO through a browser.
2. Select Virtual Media in the Virtual Devices tab.
3. Select a diskette drive or diskette image and click Connect.
4. Load the USB drivers, using the following commands:
5. Load the SCSI disk driver, using the following command:
6. Mount the floppy drive, using the following command:
Connect. Alternatively, select a diskette image to be used and click
Connect.
modprobe usbcore
modprobe usb-storage
modprobe usb-ohci
modprobe sd_mod
mount /dev/sda
NOTE: Use the man mount command for additional file system types.
/mnt/floppy –t vfat