HP 2240 Owner's Manual page 234

Changing the Console to External Terminal
To select a new Graphics Monitor Type press
the <TAB> key now, otherwise EXIT by entering
any other key (or will time out in 15 se-
conds)...
To restart the monitor selection process,
press TAB.
In the event that your console stops displaying to your graphics de-
vice, use the following procedure to display the console to an external
terminal:
1. Turn system power off.
2. Disconnect the PC keyboard connector from the system rear
panel.
3. Connect a serial terminal to the Serial 1 connector (the left
serial connector) on the system rear panel (PCI/EISA as-
sembly).
4. Power on the system.
The system will now display the console to the terminal connected to
the Serial 1 port.
D-23