HP 2240 Owner's Manual page 134

B-16
CD-ROM Drive
The CD-ROM drive ships with the drive set to SCSI ID address
2. We recommend keeping the address setting at 2 unless it is
used by another device.
CAUTION: CD-ROM drives are susceptible to mechanical
and electrostatic shock. When handling the drive,
always wear the static-grounding wrist strap that
came in the CD-ROM drive kit. Always handle
the drive carefully.
If you need to change the CD-ROM drive's address, follow these
instructions, referring to Figure B–8. If you do not need to
change the drive's address, go to Step 10 of this installation pro-
cedure.
1. Locate the jumpers at the back of the CD-ROM drive.
2. To change the address, use needlenose pliers to set the
drive's SCSI ID to an address that is not used by another
SCSI device. Check that the other jumpers are set correctly.
NOTICE: Do not use SCSI ID 7 for your CD-ROM drive's
SCSI address. The host SCSI controller uses
SCSI ID 7.
3. Use needlenose pliers to remove the SCSI terminators, if
still attached to the drive.