Displaying And Setting The Fastboot Mode - HP 2240 Owner's Manual

Displaying and Setting the Fastboot Mode

D-34
When fastboot is enabled (set to on), your workstation does a quick
check of the memory and skips I/O interface testing during its power–
on self tests. This enables your workstation to complete its boot pro-
cess quicker. The default factory setting is for fastboot to be enabled
(on).
The fastboot mode allows your workstation to boot quickly by per-
forming a less extensive check of the system's memory.
When fastboot is disabled (set to off), more extensive memory test-
ing and I/O interface testing is performed during the self tests, caus-
ing the boot process to take longer.
If you are experiencing difficulty in booting your workstation, set
fastboot to off and reboot the system. The more extensive testing
may reveal the error condition.
To display the status of fastboot, type the following at the prompt:
Configuration Menu: Enter command > fastboot
To disable fastboot, type the following at the prompt:
Configuration Menu: Enter command > fastboot off
To enable fastboot, type the following at the prompt:
Configuration Menu: Enter command > fastboot on