Media Drive Replacement Kit; Replacing The Media Drive; Configuring The New Drive - Extron electronics VNR 100 User Manual

Media Drive Replacement Kit

Replacing the Media Drive

1.
2.
3.
4.
5.
6.
7.
8.
9.

Configuring the New Drive

Initial configuration is through the browser of a computer
connected to the same network as the VNR 100.
1.
2.
If necessary, switch the recorder off by pressing and holding down the power switch
a
(figure 14, ) until the LEDs
ATTENTION: Never remove or insert the drive while the unit is powered on.
Unplug the recorder.
Press the red catch (see the
figure to the right). The lever
arm is released.
Swing the lever arm out until
it is perpendicular to the front
of the drive caddy (see the
figure to ther right). Use the
arm to pull the caddy out of
the drive bay.
Remove the drive. There are
no screws to be removed or
cable connections to be undone.
Insert the new drive into the drive bay.
Push the caddy back into the recorder.
Swing the lever arm back until it clicks into place behind the catch.
NOTE: When the new drive is correctly seated, all necessary connections are
automatically formed.
Reconnect the power to the VNR 100 and power it on by pressing the power switch.
In the browser address bar, enter the IP address of
the recorder followed by a colon and the port number
(for example
192.168.254.254:8080
page opens (see the figure to the right).
Enter the and
Username Password
NOTE: By default, the
Username
are both
Password config
b
(figure 14, ) flash red and then go out.
). The login
.
and
.
VNR 100 • Replacing the VNR 100 Drives 18