Alliedware Operating System Startup On At-8948, X900-48Fe, X900-48Fs, And At-9900 Switches - Allied Telesis x900-48FE Hardware Reference Manual

54
Process flow
Overrides
Regular output
AlliedWare Operating System Startup on
AT-8948, x900-48FE, x900-48FS, and AT-9900
Switches
When the AT-8948, x900-48FE, x900-48FS, or AT-9900 switches start, they
perform the following operations.
Stage This happens...
1 Self-tests run that check basic operations.
2 A prompt is displayed briefly to allow a user-override. Users can
change the startup process by pressing special keys (see
Overrides). If they enter nothing, the process continues.
3 The flash boot release is loaded as the install software.
4 Install information is checked and the switch boots up from
either the preferred or default install.
5 The startup configuration script that the user specified is
executed.
6 Startup is complete and the switch starts switching traffic if
devices connected to it are sending traffic.
The switch pauses briefly during routine startup messages to display the
following prompt:
Force EPROM download (Y)?
If you do nothing, switch software is loaded along with a preconfigured
startup script. For troubleshooting, change the process by using the following
keys.
Pressing this key... Forces the switch to...
Y Load the flash boot release with no patch.
S Start with the default configuration so that any boot script is ignored.
Ctrl+D Enter diagnostics mode. For more information, see
page
The following messages are an example of output from the AT-8948,
x900-48FE, x900-48FS, and AT-9900 series switches.
INFO: Self tests beginning.
INFO: RAM test beginning.
PASS: RAM test, 131072k bytes found.
INFO: BBR tests beginning.
PASS: BBR test, 512k bytes found.
INFO: Self tests complete
INFO: Downloading switch software.
Force EPROM download (Y) ?
INFO: Initial download succeeded
INFO: Executing configuration script <boot.cfg>
INFO: Switch startup complete
x900 Series Switch and SwitchBlade
58.
®
x908
Done by...
Boot ROM
Boot ROM
Boot ROM
Boot ROM
Preferred or
default software
Release software
"Diagnostics" on
C613-03092-00 REV J