Bringing Up The Osd Menus; Navigating Through The Osd Menus - Barco MDNC-2221 User Manual

4.4

Bringing up the OSD menus

How to bring up the OSD menus
The OSD menu allows you to configure different settings to make your NIO 2MP LED Display fit your
needs within your working environment. Also, you can retrieve general information about your display
and its current configuration settings through the OSD menu.
Bringing up the OSD menus can be done by:
1. If not already done so, switch on the display as previously described.
2. Illuminate the keys as previously described.
3. While the keys are illuminated, touch the menu key.
As a result, the OSD main menu comes up in the bottom right corner of the screen. However, if no further
actions are taken within the following 90 seconds, the OSD will disappear again.
The OSD menu auto-exit function can be disabled in the OSD menu. Please refer to
"OSD menu automatic close function", page 19 for detailed instructions on how to do
this.
4.5

Navigating through the OSD menus

How to navigate through the OSD menus
Navigating through the OSD menus can be done by:
• Use the left/right keys to move through the (sub)menus, change values or make selections.
• To go into a submenu or confirm adjustments and selections, use the menu key.
• Use the standby key to cancel adjustments or exit a (sub)menu.
• Exit all OSD menus at once by touching the standby key for approximately 2 seconds.
The key icons are displayed above the keys, adapted to the function that it is used for
(menu dependent).
Overview key icons
K5903058 NIO 2MP LED DISPLAY 04/03/2014
Left, Right
Menu
Enter
4. Daily operation
17