Table of Contents
Advertisement
Mode:
Set the speed and duplex of the port. In speed, if the media is 1Gbps
fiber, it is always 1000Mbps and the duplex is full only. If the media is TP,
the Speed/Duplex is comprised of the combination of speed mode,
10/100/1000Mbps, and duplex mode, full duplex and half duplex. The
following table summarized the function the media supports.
Media type
1000M TP
ON/OFF
1000M Fiber
ON/OFF
In Auto-negotiation mode, no default value. In Forced mode, default
value depends on your setting.
Flow Control:
There are two modes to choose in flow control, including Enable and
Disable. If flow control is set Enable, both parties can send PAUSE frame
to the transmitting device(s) if the receiving port is too busy to handle.
When it is set Disable, there will be no flow control in the port. It drops
the packet if too much to handle.
Default: Enable.
Wait State:
For more details about this parameter please refer to section 3-2-1.
Default: Disable.
NWay
Speed
10/100/1000M
1000M
51
Duplex
Full for all, Half for 10/100
Full
Advertisement
Table of Contents
