Table of Contents
Advertisement
Parameter description:
Trap:
Cold Start, Warm Start, Link Down, Link Up, Authentication Failure, User login, User
logout
STP:
STP Topology Changed, STP Disabled, STP Enabled
LACP:
LACP Disabled, LACP Enabled, LACP Member Added, LACP Port Failure
GVRP:
GVRP Disabled, GVRP Enabled
VLAN:
VLAN Disabled, Port-based VLAN Enabled, Tag-based VLAN Enabled, Metro-mode
Vlan Enabled, Double-tag Vlan Enabled
Module Swap:
Module Inserted, Module Removed, Dual Media Swapped
Function name:
Email/SMS Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the
alarm message via either email or SMS, or both. It depends on your settings.
An email address or a mobile phone number has to be set in the web page of
alarm configuration (See Fig. 3-60). Then, user can read the trap information
from the email or the mobile phone. This function provides 6 email addresses
and 6 mobile phone numbers at most. The 24 different trap events will be sent
out to SNMP Manager when trap event occurs. After ticking trap events, you
can fill in your desired email addresses and mobile phone numbers. Then,
please click <Apply> button to complete the alarm configuration. It will take
effect in a few seconds.
Note: SMS may not work in your mobile phone system. It is customized for different
systems.
122
Advertisement
Table of Contents
