Installation; Before You Begin; Cable Connection - ATEN Master View CS-1762 User Manual

Before you Begin

Make sure that all devices on the installation are properly grounded.

Cable Connection

To set up your Master View CS-1762 / CS-1764 installation, refer to the installation
diagrams on the following pages (the numbers in the diagrams correspond to the steps,
below), and do the following:
1. Plug your USB keyboard and USB mouse into the USB Console Ports located on the
unit's front panel.
2. Plug your microphone, speakers, and monitor into the Console ports located on the
unit's rear panel.
3. Using a KVM cable set (provided with this package), plug the DVI connector into
any available DVI socket in the CPU Port section of the switch, and plug the
accompanying USB, microphone and speaker connectors into the corresponding
USB, microphone, and speaker sockets.
Note: 1. Be sure that all the plugs are in the same CPU Port sockets (all in Port 1, all
in Port 2, etc.).
2. Each socket is marked with an appropriate icon to indicate itself.
4. At the other end of the cable, plug the USB, video, microphone and speaker cables
into their respective ports on the computer.
5. Plug your USB peripherals into the type A sockets in the USB hub section.
6. Plug the the power adapter that came with your switch into an AC power source, then
plug power adapter cable into the switch's Power Jack.
7. Turn on the power to the computers.
8

Installation

2004-06-04
Chapter 2.