Firmware Upgrade Mode; Restore Default Settings; Hsm Summary Table - ATEN Master View CS-1762 User Manual

Firmware Upgrade Mode

To set the CS-1762 / CS-1764 to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see p. 16).
2. Key in: upgrade
3. Press [Enter].
The front panel LEDs flash to indicate Firmware Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.

Restore Default Settings

To reset the CS-1762 / CS-1764 to its default hotkey settings, do the following:
1. Invoke HSM (see p. 16).
2. Press [R] [Enter].
All hotkey settings return to the factory default settings. See p. 29 for a list of default
settings.

HSM Summary Table

After invoking HSM (see p. 16), key in one of the following keys to perform the
corresponding function:
Key
H Toggles between the default and alternate HSM invocation keys.
T Toggles between the default and alternate Port Switching keys.
F2 Sets the Mac keyboard operating platform.
F10 Auto detects the keyboard operating platfrom. (PC Compatibles)
F4
Lists the current hotkey settings via the Paste function of a text editor
or WP.
F5
Performs a USB reset.
B Toggles the beeper On and Off.
X [Enter]
Enables/Disables the Port Switching keys.
R [Enter] Resets the hotkey settings to their default status.
upgrade [Enter] Invokes Firmware Upgrade Mode
Hotkey Operation
Function
2004-06-04
19