Table of Contents
Advertisement
Chapter 3: Cabling and Configuration
Setting the Enclosure ID
This Chapter describes the procedure for connecting your
SANbloc Series to a host computer(s). Detailed information
on how to configure and daisy chain enclosures is also
provided along with instructions on how to set the enclosure
ID.
Each of the fourteen disk drive slots of the SANbloc
Series has a unique identifier assigned to it. This identifier is
assigned using a combination of the Slot number and the
enclosure ID.
The enclosure ID is set, using the enclosure ID switch,
located on the rear of the SANbloc (see Figure 3-1).
Note: The enclosure ID must be set prior to powering on the
enclosure.
Note: Each enclosure must have a seperate ID when daisy
chained together.
Setting the Enclosure ID
31
Advertisement
Table of Contents
