Before Using Your Electronic Control Oven - Electrolux EOEM61AS, EOEE62AS,EOEE63AS User Manual

10 before using your electronic control oven electrolux e:line ovens

Before using your electronic control oven

Preparing your oven
1. Please remove all stickers, leaflets and boxes from the
doors and the floor of the oven before operation.
2. Please wipe out the oven interior prior to operation with
warm soapy water and polish dry with a soft clean cloth.
Do not close the oven door until the oven is completely dry.
Setting the time (EOEE62AS, EOEE63AS, EPEE63AS,
EUEE63AS, EDEE63AS)
After electrically connecting the appliance, you must set the
time of day before you can operate your oven.
1. After the appliance has been electrically connected
"12:00" will flash on the clock display, along with the
scrolling message "Welcome to Electrolux".
2. To set the time of day in hours and minutes, press the
or buttons.
3. 8 seconds after the last change the time will stop flashing,
confirming the time has been set. Once the time has
been entered, the clock advances minute by minute.
Note:
• T he clock has a 12 hour display
• The display has 3 levels of brightness.
– Brightest illumination: whenever the oven is in use.
– Medium illumination: the oven is not in use.
– L owest illumination: the oven is not in use between
the hours of 10pm and 6am.
Setting the time (EOEK62AK)
• A fter the appliance has been electrically connected,
the set clock symbol and timer arrow
the clock display.
• To set the time of day, press – or +. 5 seconds after the
last change the timer arrow
the time has been set. Once the time has been entered,
the clock advances minute by minute.
Note:
• The clock has a 24-hour display.
tips and information
New appliances can have a smell during first use. It is
recommended to 'run in' the oven before you cook for
the first time. Operate the oven empty at a temperature
of 180°C for approximately 2-4 hours (see page 14 for
operating sequence). Please ensure the room is well
ventilated during this process.
will flash on
will disappear, confirming
Installing your oven accessories
• Catalytic liners (if supplied)
The oven/s will already be fitted with a catalytic fan baffle
and top panel. We have supplied side panels for you
to fit. They can be fitted before you put the side racks
on but you can omit them, if you wish, with no effect
to cooking performance. Their sole purpose is to make
oven cleaning easier. Of course, you can add them at
any time by removing the side racks (see page 24).
The catalytic liners will attach to each side of the oven.
There will be a left hand and a right hand version.
1. Position the first liner as per the diagram. The black,
shiny side of the liner should be facing the oven wall,
the hooks pointing down and the front edge will have
a narrow strip before the vertical slot (when compared
to the strip at the rear edge). Note that the diagram
shows the left hand liner. The right hand side will be
a mirror image of this.
2. Line the hooks up with the slots provided in the
oven wall, push them in and then allow the liner to
slide down to its final position. All 4 hooks MUST
be engaged in slots.
3. The access hole for the side racks should be visible
when the liner is correctly positioned – see diagram.
Note:
• I f you have purchased an EDEE63AS or an EUEE63AS
you will have additional side panels for the extra oven
cavity.