Electrolux EOEM61AS, EOEE62AS,EOEE63AS User Manual page 11

• Side racks and telescopic slides
1. Insert the largest peg into rear access hole provided.
2. Then locate the front peg into the front access hole
and push in firmly.
Note:
• I f you have purchased an EUEE63AS you will have
additional side racks for the lower oven/grill. These are
fitted in the same manner, however the left hand side
rack must be fitted to the lower two holes of the oven/
grill cavity.
• Shelves and trays
The shelves are designed so that they have maximum
extension but cannot be accidentally pulled right out.
The trays are designed the same way and slot straight
into the side racks.
To fit a shelf or tray to side racks:
1. Locate the rear edge of the shelf/tray in between 2
guide rails of the side rack – see diagram. Ensure
the same rail positions on both sides of the oven are
being engaged.
2. With the front edge raised, begin to slide the shelf into
the oven.
3. Once the detents have passed the front edge of the
side rack, the shelf can be pushed completely in.
When fully inserted the shelf/tray should not interfere
with the closed oven door.
electrolux e:line ovens before using your electronic control oven 11
To fit a tray to telescopic slides:
1. Fully extend the slides on both sides.
2. Select the tray you wish to use and position the slots
on one side on the respective tabs of the slide.
3. Drop the other side down so that the tray is fully
seated on both slides.
When fully inserted the shelf/tray should not interfere
with the closed oven door.
• Fat filter (if supplied)
The fat filter is designed to go onto the front of the fan
cover at the rear of the oven. When fully engaged the
filter will be positioned in the centre of the fan cover.
1. Locate the mounting slots in the fan cover and the
corresponding tags on the fat filter.
2. Position the fat fiter onto the fan cover with the tags
pointing down.
3. Push the fat filter down into position.