Troubleshooting; Notes - Westinghouse WSF6608X User Manual

TROUBLESHOOTING

PROBLEM SOLUTION
If one of program monitor lights is • Your machine's door is open, shut the door .
on and start/pause light is flashing
If the program won't start • Check if the plug is connected .
• Check your indoor fuses .
• Be sure that the water inlet tap is turned on .
• Be sure that you have closed the machine door .
• Be sure that you switched off the machine by pressing the Power On/Off button .
• Be sure that the water inlet filter and the machine filters are not clogged .
• First time use: Check if the drain spigot's membrane has been removed or
spigot blocked .
• Check if the delay start has been selected – reset .
If detergent residues are left in the • Detergent has been added when the detergent compartment was wet .
detergent compartment
• A large dish in the lower basket has blocked the dispenser door .
If water is left inside the machine • The water drain hose is clogged or twisted .
at the end of the program
• The filters are clogged .
• The program is not finished yet .
If the machine stops during a wash
• Power failure .
operation
• Water inlet failure .
• Program can be on standby mode .
If shaking and hitting noises are heard • Dishes placed incorrectly .
during a wash operation
• Spray arm hitting the dishes .
If there are partial food wastes left on • Dishes placed incorrectly into the machine, sprayed water did not reach related places .
the dishes
• Basket over loaded .
• Dishes leaning against one another .
• Very small amount of detergent added .
• An unsuitable, rather weak wash program selected .
• Spray arm clogged with food wastes .
• Filters clogged .
• Filters incorrectly fitted .
• Water drain pump clogged .
If there are whitish stains on the dishes • A very small amount of detergent is being used .
• Rinse aid dosage setting at a very low level .
If the dishes won't dry up • A program without a dry operation selected .
• Rinse aid dosage set too low .
• Dishes unloaded too fast .
If there are rust stains on the dishes • Stainless-steel quality of the dishes washed is insufficient .
• Unhealthy mains grounding .
Call an authorised service centre if the problem still
persists after the controls or in case of any malfunction
not described above.
24
FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

NOTES

TROUBLESHOOTING
25
TROUBLESHOOTING