TRENDnet TV-IP662PI User Manual page 50

TRENDnet User's Guide
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This unit is to be used with the power supply provided by the manufacturer.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
Europe – EU Declaration of Conformity
This device complies with the essential requirements of EMC directive 2004/108/EC. The
following test methods have been applied in order to prove presumption of conformity
with the essential requirements of EMC directive 2004/108/EC:
EN 60950-1: 2006+A11:2009+A1:2010+A12:2011.
Safety of Information Technology Equipment
EN55022:2010/AC:2011
Information technology equipment - Radio disturbance characteristics - Limits and
methods of measurement
EN55024:2010
Information technology equipment - Immunity characteristics - Limits and methods of
measurement
© Copyright 2014 TRENDnet. All Rights Reserved.
EN61000-3-2:2006+A2:2009
Electromagnetic compatibility (EMC) -- Part 3-2:Limits - Limits for harmonic current
emissions (equipment input current <= 16 A per phase)
EN61000-3-3:2008
Electromagnetic compatibility (EMC) - Part 3-3:Limits - Limitation of voltage changes,
voltage fluctuations and flicker in public low-voltage supply systems, for equipment with
rated current <= 16 A per phase and not subject to conditional connection
Limited Warranty
49