LG LW130W User Manual page 19

Initial Configuration and Operation
3. Log on to LG Smart Web Viewer
LG Smart Web Viewer runs on most of the web browsers.
We recommend Windows Internet Explorer for this
application.
3.1 Run IP Utility software to search of any LG IP Device.
3.2 Once the search result screen is up, you may either
double click on the detected LG IP devices or right
click them to select [Connect to Web Page] menu.
If the connection is successfully established, a log
on pop up window will show up.
3.3 Input your username and password.
(The default administrator username and password
are both set to 'admin' from the factory.)
3.4 Click [OK], and LG Smart Web Viewer Screen
comes up in your web browser.
Note:
• There is an alternative way to access to LG
Smart Web Viewer, as follows;
3.1 Launch your web browser.
3.2 Input the IP address of the target LG IP
device on the address bar of your web
browser, and then press 'Enter' on your
keyboard.
3.3 Input your username and password.
3.4 Click [OK], and LG Smart Web Viewer Screen
comes up in your web browser.
• The launching of LG Smart Web Viewer may take a
few minutes in accordance with your network condition.
• If the log on window does not pop up, check whether
the pop-up blocking mode is activated, and deactivate
the pop-up blocking mode in your web browser's settings.
• When connecting to an LG IP device for the first time,
a security warning message will be displayed for the
installation of the operating programs for Smart Web
Viewer. Make sure you say yes for the installation.
Without the program, LG Smart Web Viewer software
will not work properly.
• When your network or computer has a firewall activated
or proxy setting, LG Smart Web Browser would not run.
Change the proxy or firewall settings to allow LG Smart
Web Browser to run.
19