Preparing For Installation - Cisco uBR-3x10 Hardware Installation And Cabling Manual

Chapter 2

Preparing for Installation

In addition, you might need the following cables:
•
•
•
Verifying the Shipping Container Contents
When you receive your Cisco uBR 3x10 RF Switch, use the following procedure to check the contents
of the shipping container. Use the installation checklist and the component list to ensure that you
received all the components you ordered.
Do not discard the shipping container. You will need the container if you move or ship your
Note
Cisco uBR 3x10 RF Switch in the future.
Verify that the following are included in the shipping container (the accessories box might be separate):
Step 1
•
•
Check the contents of the accessories box against the installation checklist and the packing slip to verify
Step 2
that you received all listed equipment, which should include everything listed in
ordered Cisco IOS software or other documentation.
After provisioning the headend as documented in the next section, refer to the
Step 3
Switch with the Cisco uBR10012 CMTS" section on page 3-3
OL-1984-06
Straight through cable
Rollover cable
Crossover cable
One Cisco uBR 3x10 RF Switch chassis containing all the components you ordered for your system
One or more accessories boxes (some or all might be shipped separately)
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
Verifying the Shipping Container Contents
Table 2-2
"Rack-Mounting the RF
to begin the installation.
and any
2-11