Cisco uBR-3x10 Hardware Installation And Cabling Manual page 16

About the Cisco uBR 3x10 RF Switch
Other chassis features include:
Front panel serviceability—for no downtime on RF interfaces. All active modules can be replaced
•
from the front panel.
10BASE-T Ethernet interface over which you can control the configuration and operation of the
•
Cisco uBR 3x10 RF Switch by means of SNMP from a Cisco universal broadband router.
• Upstream and downstream assembly online insertion and removal (OIR) or "hot swapping"
capability.
CLEI codes for all replaceable modules.
•
• Rack-mountable—Each unit can be rack-mounted into any rack or cabinet that is designed per
EIA-310 or MIL-STD-189 using the supplied rack-mount brackets.
The Ethernet controller, power supply, upstream modules, and downstream modules are accessed from
the front of the chassis. (See
Figure 1-1
1
1 Ground lug installation location
2 Power supply
3
Ethernet controller module
4 Blank slot
Figure
Note
mounted at the rear of the chassis.
The CMTS, PROTECT, and CABLE PLANT MCX connections are accessed from the rear of the
RF switch chassis. (see
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
1-2
Figure
Front View of the Cisco uBR-3x10 RF Switch
2
4
3
1-1shows the mounting brackets located at the front of the chassis. The brackets can also be
Figure 1-2.)
1-1.)
5 Downstream switch modules (3)
6 Mounting brackets
7
Upstream switch modules (10)
Chapter 1 Cisco uBR-3x10 RF Switch Overview
7
6
5
OL-1984-06