Cisco uBR-3x10 Hardware Installation And Cabling Manual page 47

Chapter 3 Installing the Cisco RF Switch
Installing the Brackets on the Cisco uBR 3x10 RF Switch Chassis
This section explains how to install the rack-mount brackets on a Cisco uBR 3x10 RF Switch for
flush-rear installations as shown in
rack-mount brackets so that the MCX connector side of the RF switch (coinciding with the RF cable
interfaces on the Cisco uBR7246VXR CMTS) faces the rear of the rack.
Equipment
•
•
•
To install the rack-mount brackets on the chassis for a flush-rear configuration, complete the following
steps:
Locate the threaded holes on the rear sides of the chassis.
Step 1
Align the first rack-mount bracket with the threaded holes in the rear right side of the chassis. See
Step 2
Figure
Thread the M5 x 8-mm Phillips countersunk screws through the rack-mount bracket and into the side of
Step 3
the chassis. Use a number 2 Phillips screwdriver to tighten the screws.
Repeat
Step 4
Figure 3-6
OL-1984-06
Two Brackets (Cisco part number 74-2620-01)
Four M5 x 8-mm Phillips countersunk screws
Number 2 Phillips screwdriver
3-6.
Step 1 through Step 3 for the other rack-mount bracket.
Installing the Rack-Mount Brackets on the Cisco uBR 3x10 RF Switch (Rear Mount)
Front
Rack-mount
bracket
Rack-Mounting the RF Switch with the Cisco uBR7246VXR CMTS
Figure 3-5 on page 3-10. We recommend that you install the
Rear
Cisco uBR-3x10 RF Switch Hardware Installation and Cabling Guide
Rack-mount
bracket
3-11