Mounting The Switch On A Wall - Cisco Catalyst 3750 Hardware Installation Manual

Chapter 2 Switch Installation

Mounting the Switch on a Wall

For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood-mounting backboard. Mount the switch with the front panel facing up, as
shown in
Warning To comply with safety regulations, mount the switches on a wall with the front panel facing up.
Statement 266
Figure 2-43 Mounting the Switch on a Wall
1
1 User-supplied screws
After the switch is mounted on the wall, you might need to perform these tasks to complete the
installation, run the setup program, and access the switch:
•
•
•
•
OL-6336-06
Figure 2-43.
(Optional) Connect the switches in the stacks. See the
Ports" section on page 2-32.
Power on the switch. See the
stacked, see the "Planning Considerations" section on page 2-9
considerations.
Connect to a 10/100 or 10/100/1000 port and run Express Setup. See the Catalyst 3750 Switch
Getting Started Guide for instructions.
Connect to the front-panel ports. See the
on page 2-41 and the "Connecting to an SFP Module" section on page 2-43
installation.
"Connecting StackWise Cable to StackWise
"Verifying Switch Operation" section on page
"Connecting to the 10/100 and 10/100/1000 Ports" section
Catalyst 3750 Switch Hardware Installation Guide
Installing the Switch
1
2-7. If the switches are
for information on powering
to complete the
2-31