General Mediaaccess Gateway Troubleshooting - Technicolor MediaAccess TG799vn Setup And User Manual

11.2 General MediaAccess Gateway Troubleshooting

None of the LEDs light up (MediaAccess Gateway does not work)
Make sure that:
The MediaAccess Gateway is plugged into a power socket outlet.

You are using the correct power supply for your MediaAccess Gateway device.

The power requirements for your MediaAccess Gateway are clearly indicated on the identification label of the
MediaAccess Gateway. Only use the power adaptor supplied with your MediaAccess Gateway.
The MediaAccess Gateway is turned on via the push button or rocker switch on the back panel.

The Broadband LED does not light up or is blinking
Make sure that:
The DSL cable is correctly connected. For more information, see

Service Provider's
The DSL service is enabled on your telephone line. For more information, contact your Internet Service Provider.

The Internet LED does not light up
If you must authenticate to connect to the Internet, make sure that your user name and password are correct.
Proceed as follows:
1 Browse to the MediaAccess Gateway
For more information, see
2 On the Broadband menu, click Internet Services.
3 Under Internet, click View More.
4 Check your user name
5 Re-enter your password.
6 Click Connect.
MediaAccess Gateway unreachable
If you can not access your MediaAccess Gateway via your web browser or the Setup wizard, you might consider a hardware
reset as described in
DMS-CTC-20110713-0016 v2.0
Network".
GUI.
"Accessing the MediaAccess Gateway GUI" on page
"11.7 Reset to Factory Defaults" on page
"3.1 Connecting the MediaAccess Gateway to your
37.
116.
11 SUPPORT
111