Access From The Internet - Technicolor MediaAccess TG799vn Setup And User Manual

4 CONFIGURATION TOOLS

4.3 Access From the Internet

Modes
To access your MediaAccess Gateway from the Internet, you can choose between two modes:
Permanent Mode (Remote Access):

The remote session ends when you disable remote assistance or after restarting your MediaAccess Gateway.
Temporary Mode (Remote Assistance):

The remote session ends when you disable remote assistance, after restarting your MediaAccess Gateway or after 20
minutes of inactivity.
To enable Remote Assistance / Remote Access.
Enabling remote assistance is only possible when you are connected to the Internet.
To enable remote assistance/access:
1 Browse to the MediaAccess Gateway GUI.
For more information, see
2 Complete and check the following parameters:
 Mode:
Select the mode that you want to use.
URL:

Contains the URL that must be used to access the MediaAccess Gateway from the Internet.
 User name and Password:
Contains the user name and password are needed to access your MediaAccess Gateway remotely. If wanted you can
change the automatically generated password in the Password box.
3 Click Enable Remote Assistance.
Accessing your MediaAccess Gateway from the Internet
Proceed as follows:
1 Open your web browser.
2 Type the URL that was listed in the URL field on the Remote Assistance page (for example https://141.11.249.150:51003).
You can replace the IP address in this URL by the dynamic DNS host name if you enabled and configured
Dynamic DNS. For more information, see
Example: https://141.11.249.150:51003 can be replaced by https://mygateway.dyndns.org:51003.
3 Enter the user name and password that you specified on the Remote Assistance page.
4 The MediaAccess Gateway GUI appears.
It is now possible for a remote user to access your MediaAccess Gateway via the specified URL using the provided user
name and password.
42
"Accessing the MediaAccess Gateway GUI" on page
Dynamic
37.
DNS.
DMS-CTC-20110713-0016 v2.0