Removing The Hard Disk Drive (User-Replaceable); Figure 2-4. Removing The Hard Disk Drive; Table 2-4. Hard Disk Drive Replacement Part Numbers - HP DesignJet 500 Service Manual

Removing the Hard Disk Drive
(User-Replaceable)
Description
Drive, hard disk (7.5 GB, 9.5 mm, Hitachi)
Drive, hard disk (7.5 GB, 9.5 mm, IBM)
Drive, hard disk (10 GB, 9.5 mm, IBM, DJSA-210)
Drive, hard disk (10 GB, 9.5 mm, Toshiba,
MK1016 GAP)
Drive, hard disk (20 GB, 9.5 mm, IBM, DJSA-220)
Drive, hard disk (30 GB, 9.5 mm, IBM part no.
07N6714)
Required Equipment
#0 Phillips screwdriver.
Removal Procedure
1. Unplug the AC adapter, if present, and remove the battery.
2. From the bottom of the unit, remove the hard drive retaining screw.
3. Carefully pull the hard drive out of the computer.
4. Remove all four screws from the tray and drive case, then lift the drive out of the tray.
5. Notice that the hard drive has a pin connector attachment at one end. Carefully remove this
connector from the end of the drive. Work alternately at each side so that the connector slides off
evenly without bending the connector pins.
2-6 Removal and Replacement

Table 2-4. Hard Disk Drive Replacement Part Numbers

Figure 2-4. Removing the Hard Disk Drive

Part Number Exchange Part Number
0950-4011 F2112-69002
0950-4030 F2112-69003
0950-3934 F1660-69112
0950-3985 F2072-69109
0950-3935 F1660-69113
0950-4162 F2072-69115
Screw, M2×3mm
HP Omnibook 500