Removing the Hard Disk Drive
(User-Replaceable)
Description
Drive, hard disk (2.1GB, 9.5mm, IBM) *
Drive, hard disk (2.1GB, 12.7mm, Toshiba)
Drive, hard disk (3.2GB, 9.5mm, IBM) *
Drive, hard disk (3.2GB, 12.7mm, Toshiba)
Drive, hard disk (4.0GB, 12.7mm, IBM) *
Drive, hard disk (4.0GB, 12.7mm, Toshiba)
*
Recommended replacement parts. HP recommends stocking drives from IBM, the primary hard drive
source for these OmniBook products. IBM drives can be used with the older HDD case that has no top
shield (the shield should be installed if it is present). Toshiba hard drives require a top shield as part of the
HDD case.
Required Equipment
Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the two screws from the bottom of the hard drive.
3. Pull out the hard drive.
Caution
Work the connector off the hard drive evenly, without pulling on the flex cable. Otherwise, you
may bend connector pins on the hard drive or damage the flex cable.
HP OmniBook 2100/3000/3100
Table 2-4. Hard Disk Drive Replacement Part Numbers
Part Number
0950-2801
0950-2836
0950-2802
0950-2854
0950-2671
0950-2865
Screw, M2.5×5mm
Figure 2-3. Removing the Hard Drive
Exchange
OmniBook
Part Number
2100
F1385-69100
F1350-69100
F1348-69103
F1348-69102
F1386-69100
F1386-69101
Removal and Replacement
3100
3000
2-5