Intermittent Pilot Lighting Instructions - Empire Comfort Systems DVP36DP31N-2 Installation Instructions And Owner's Manual

Direct vent zero clearance gas fireplace heater
Hide thumbs Also See for DVP36DP31N-2:
Table of Contents

Advertisement

INTERMITTENT pILOT LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance
area for gas. be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
• do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
1. STOp! Read the safety information above.
2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
GAS CONTROL KNOB
SHOWN IN "OFF" POSITION.
5. Lower louver front assembly.
1. Set the thermostat to lowest setting. (if applicable.)
2. Turn off all electric power to the appliance if service is
to be performed.
3. Open bottom louver assembly.
Page 54
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO AppLIANCE
the fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it; call a qualified service technician. Force or
attempted repair may result in a fire or explo-
sion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified ser-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
6. Turn gas control knob clockwise
"oFF."
7. Wait ten (10) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, SToP! Follow "b" in the safety information
above. If you don't smell gas, go to the next step.
8. Turn gas control knob counterclockwise
to "on".
9. Close louver front assembly.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions "To TURn oFF GAS To APPLIAnCe"
and call your service technician or gas supplier.
4. Turn gas control knob clockwise
not force.
5. Close bottom louver assembly.
to
to "OFF". Do
26927-8-0611

Advertisement

Table of Contents
loading

Table of Contents