Fbb4 Variable Speed Blower Installation - Empire Comfort Systems DVP36DP31N-2 Installation Instructions And Owner's Manual

Fbb4 VARIAbLe SPeeD bLoWeR InSTALLATIon

Attention: Install blower assembly before connecting gas inlet
supply line
NOTICE: junction box on right side of fireplace must be pre-
wired at time of fireplace installation for use with blower
assembly. It is recommended that an ON/OFF wall
switch be installed that will activate the power supply
to the furnace by a qualified electrician.
1. If installed, turn OFF gas supply to fireplace.
2. If applicable, turn OFF electric supply to fireplace.
3. Lower bottom louver on fireplace.
4. Refer to page 71, "Junction Box Wiring Installation Instructions"
to complete wiring of junction box.
Attention: If installed, do not damage gas inlet supply line
when blower assembly is inserted into fireplace. If
necessary, remove gas inlet supply line.
Wiring
The appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, if an external
electrical source is utilized. This appliance is equipped with
a three-prong [grounding] plug for your protection against
shock hazard and should be plugged directly into a properly
grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug. For an ungrounded receptacle,
an adapter, which has two prongs and a wire for grounding, can
be purchased, plugged into the ungrounded receptacle and its
wire connected to the receptacle mounting screw. With this wire
completing the ground, the appliance cord plug can be plugged
into the adapter and be electrically grounded.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. verify proper operation after servicing.
Blower Motor
The blower motor does not have oiling holes. Do not attempt to
oil the blower motor.
Blower Wheels
The blower wheels will collect lint and could require periodic
cleaning. If the air output decreases or the noise level increases,
it indicates a dirty blower wheel. Remove fan and clean blower
wheels.
Unplugging of blower accessory will not stop the heater
from cycling. To turn off gas to the heater (millivolt model):
push in gas control knob slightly and turn clockwise to
"oFF." Do not force. To turn off gas on direct ignition model,
turn gas line valve to "oFF."
26927-8-0611
CAUTION
WARNING
5. Insert blower assembly into interior, bottom of fireplace.
Position blower assembly behind gas valve, align notch on back
of blower assembly with center screw on fireplace back and
push blower assembly against fireplace back. The magnets on
the back and bottom of blower assembly will sufficiently hold
blower assembly in place.
6. Position speed control box to the right of gas valve. Attach
speed control box to bottom of fireplace. The magnets on
bottom of speed control box will sufficiently hold speed control
box in place.
7. With base (flush face) of fan control switch facing upward,
insert base of fan control switch under the mounting tabs on
valve bracket. The base (flush face) of fan control switch must
be in contact with bottom of firebox.
8. Insert power cord plug into junction box.
9. Close bottom louver on fireplace.
10. Installation of FBB4 optional variable speed blower assembly
is completed.
FAN KIT
FAN SWITCH
*NOTICE: Refer to Junction Box wiring
instructions on page 53 and 71 for proper
operation.
SEE NOTE*
JUNCTION BOX
SPEED CONTROL
VALVE BRACKET
SWITCH HOLDER
(TOP OF VALVE BRACKET)
Page 69