Full / Half-Duplex Selection - Advantech ADAM-6541 User Manual

2.3 Full / Half-Duplex Selection

There are two modes of data transmissions, full-duplex and half-duplex
transmission. The data can be transmitted in both directions on a single
carrier at the same time when you select Full-duplex mode. But the data
can only be transmitted in one direction on a single carrier at the same
time when you select Half-duplex mode. You may select Full or half-
duplex mode according to your equipment requirements.
You can configure full or half-duplex ADAM-6541 via JP1 (located on
the top-left PCB.)
JP1
NOTE:
Fiber Transmission Distance
(1) Half duplex: 412 m
(2) Full duplex: 2 km
ADAM-6541 User Manual
Description
Half-Duplex
Full-Duplex (Default)
8